COBBLIX.COM
  • Home

Resole Kumfs Heel+Sole

Yes sure we can fix your soles ... thats all gone a bit rotten, we'll remove it all so you are right back to the leather, run a new edge around, build up the height with soft light material and then put a grippy harder wearing sole right thru on the bottom, with no joins so you wont get any splits ... now you've been into our store before .... ​

​1 Record Height Heel and Sole

Eg H=30, S=10
Heel will be, rand 4+ 2 layers 10 eva plus 6 Soft = 30mm
Sole will be Rand 4+ Soft 6=10mm

2 Remove old sole+grind

Picture
​Dig right around with wide flat screw driver, then pull off by hand or with pincers.
​Grind clean ready for glue.

​3 Cut out new soling

Picture
Only need to cut out the next layer you need.
  1. ​Rand
  2. Full sole EVA if height needed
  3. Full sole Soft
  4. Heel EVA as needed for height, use a 10mm first.
  5. Heel rubber if needed


4 Glue Rand on

Picture
Yellow Glue - leather to resin rand.
Run rand clockwise, move around shoe as you do it. Join on "inside" near back.

5 Glue EVA to the rand

Picture
Only if height is needed.
​Keep shape of shoe, don't allow the EVA to flatten the shoe out.
Yellow Glue for little old ladies shoes. Clear glue for Mens and performance footwear.

6 Grind EVA

So that sole glues well and to get rid of any bumps.

7 Glue Sole on and Trim

Picture

8 Grind sole at heel area and glue EVA block on

Picture

9 Grind EVA heel block flat

Check heel angle and heights

10 Glue heeling on and trim

Picture

Submit
Copyright © Cobblix.com 2019
  • Home