COBBLIX.COM
  • Home

Resole ​Kumfs Wedge

Yes sure we can fix your soles ... thats all gone a bit rotten, we'll remove it all so you are right back to the leather, run a new edge around, build up the height with soft light material and then put a grippy harder wearing sole right thru on the bottom, with no joins so you wont get any splits ... now you've been into our store before .... ​

​1 Record Height Heel and Sole

Picture
Eg H=30, S=10
Heel will be, rand 4+ 2 layers 10 eva plus 6 Soft = 30mm
Sole will be Rand 4+ Soft 6=10mm

​2 Cut out new soling

Picture
Only need to cut out the next layer you need.

​1 Full sole EVA if height needed
2 Full sole Soft
3 Heel wedge EVA as needed for height, use a 10mm first.
4 Heel rubber if needed


3 Remove old sole+grind

Picture
​Dig right around with wide flat screw driver, then pull off by hand or with pincers.

​ 4 Glue Rand on

Picture
Yellow Glue - leather to resin rand.
Run rand clockwise, move around shoe as you do it. Join on "inside" near back.

 5 Glue EVA to the rand

Picture
Keep shape of shoe, don't allow the EVA to flatten the shoe out.
Yellow Glue.

 6 Grind EVA to wedge

Picture
Take almost none off at heel
Remove almost all at front of wedge
Grind wedge flat so shoe sits flat.

7 Repeat 5+6 to get height

Picture
While you are putting on blocks of EVA, you are then grinding them to wedge shapes as you build up layers. 

 8 Glue Sole on and Trim

Picture
Note the little extra layer at the heel. Needed a bit more to get the height right.

Submit
Copyright © Cobblix.com 2019
  • Home